- per page
"Floating Straight Bracket", W/ Ring Sleeve works with dock pipe UP TO 2" ( 2-3/8" O.D. ) to stabilize floating docks or use bracket as a tie off for anchoring floating docks or swim rafts.
( CLICK ON DETAILS FOR DETAILED PRODUCT DESCRIPTION; PIPE CAPS AND FASTENERS )
"Inside Corner Support" can be used with the D3-430, D3-440 & D3-441.
( CLICK ON DETAILS FOR DETAILED PRODUCT DISCRIPTION; PIPE CAPS AND FASTENERS )
THIS ITEM IS OUT OF STOCK.
,"Outside Corner Angle Tie" can be used with D3-435 "Inside Corner Support" or when a float is in the way the D3-442; Square Backing Plate" may be used.
( CLICK ON DETAILS FOR DETAILED PRODUCT DESCRIPTION; PIPE CAPS AND FASTENERS )
"Section Tie Plates" are used to connect 2 ea. dock sections together. Use 2 ea. PER SIDE if sections are open ended, use 1 ea. with 2 ea. D3-435; "Inside Corner Supports" or 2 ea. D3-442; "Square Backing Plates" PER SIDE if secton ends are closed.
( CLICK ON DETAILS FOR DETAILED PRODUCT DISCRIPTION AND FASTENERS )
"Stringer Angle Bracket" is used for inside dock section stringers.
( CLICK ON DETAILS FOR DETAILED PRODUCT DISCRIPTION; PIPE CAPS AND FASTENERS )
D3-464; "Hitch Pin & Hitch Clip" ( 1 of Each). The Hitch Pin is 5/8" Dia. & the Hitch Clip is ( .148" Diam. Material ). These items are used on our D3-420 & D3-430 "Floating Dock, Section Connectors" also on the D3-486; "Corner Support Bar Assembly".
NOTE: The Hitch pin diameter is 5/8", if not used on a VE-VE Inc. manufactured floating dock bracket, make sure what you are replacing is 5/8" diameter. Other manufactures hitch pins may be smaller ( 1/2" diameter ) or larger ( 3/4" diameter ). ALSO, the effective length ( distance from form to inside of hole ) is 2-1/2" !!
"Square Backing Plate" can be used with the D3-420 "T-Section Connectors" & most other D3-400 series brackets as a back up plate on inside of dock section for added bracket support.
( CLICK ON DETAILS FOR DETAILED PRODUCT DISCRIPTION; PIPE CAPS AND FASTENERS )
"FASTENER KIT"
- (4 ea.) 3/8”-16 x 2-1/2”; Galvanized Carriage Bolts.
- (4 ea.) 3/8”-16; Galvanized Hex Nuts.
-
(4 ea.) 3/8”; Galvanized Washers.
THE D-56; 2" PIPE CAPS ARE CURRENTLY OUT OF STOCK.
,
The "Pipe Cap" fits over 2" dock pipe that is 2-3/8" O.D. These round injection molded pipe caps are made with marine grade vinyl and fit snugly over the top of the pipe for a safe and attractive finish.
NOTE: BECAUSE OF LOW INVENTORY AT THIS TIME, PIPE CAPS WILL ONLY BE SOLD ALONG WITH A DOCK BRACKET ORDER, SORRY!!
Shipping is FREE when ordered with a dock bracket order!!!!
"Backup Washer Bar" can be used with the D3-444 "Stringer Angle Bracket" or the D3-459; "Dock Ramp Roller Assembly".
( CLICK ON DETAILS FOR DETAILED PRODUCT DISCRIPTION; PIPE CAPS AND FASTENERS )
- per page