D3-459; "Dock Ramp Roller Assembly"

The "Dock Ramp Roller Assembly" is used on end of Hinged Ramps to allow end of dock ramp section to roll on other dock section or shore when Floating Dock height changes. Brackets mounting bar is 3/8" Th. x 2" H. x 6" Long & has 2 ea. 1/4" Th. x 1-1/2" W. Roller Mount tabs. The tabs are welded at a angle so that the Rollers are below the Bottom edge of the Ramp Frame. ( Galvanized Finish ).

NOTE: For added Bracket support, the hole pattern in the Bracket allows it to be mounted on inside with a D3-435; "Inside Corner Angle Tie", ( CLICK HERE ) to view D3-435. Also a D3-440; "Outside Corner Angle Tie" can be added, ( CLICK HERE ) to view D3-440. Or just a D3-446; "Backup Washer Bar" may be used, ( CLICK HERE ) to view D3-446.

NOTE: Install with 3/8” carriage bolts NOT INCLUDED. Use 1 ea. D-561; "Fastener Kit" Per 2 ea. D3-459 brackets. ( CLICK HERE ) To go to D-561; "Fastener Kit".

Plus $2.50 each shipping.